3M shall have no obligation to provide or pay for the labor required to install the repaired or replacement part. If 3M is unable to repair or replace the part within a reasonable time, then 3M, at its option, will replace the equipment or refund the purchase price. A part will be presumed to have become defective after its warranty period unless the part is received or 3M is notified of the problem no later than five (5) calendar days after the warranty period. If any 3M-warrantied part is proved to be defective within its warranty period, then the exclusive remedy and 3M’s and seller’s sole obligation shall be, at 3M’s option, to repair or replace the part, provided the defective part is returned immediately to 3M’s factory or an authorized service station designated by 3M. Please refer to individual data pages for additional details and exceptions. 3) All other parts will be free from all defects for two (2) years after delivery. 2) All other Taping Head parts will be free from all defects for three (3) years after delivery. Warranty and Limited Remedy: THE FOLLOWING WARRANTIES ARE MADE IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY, THE IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND ANY IMPLIED WARRANTY ARISING OUT OF A COURSE OF DEALING, A CUSTOM OR USAGE OF TRADE: 3M sells its 3M-Matic™ Stainless Steel Adjustable Case Sealer 700a-s with the following warranties: 1) The Taping Head knife blades, springs and rollers will be free from all defects for ninety (90) days after delivery. Infeed Conveyor Supplied L Consistent productivity in corrosive environments A C W H A* B C** F Min inches (mm) 31(787) 40.5 (1030) 53 (1346) 18 (457) 24 (610) 4 (102) 24.5 (622) Max inches (mm) 31(787) 40.5 (1030) 86 (2184) 18 (457) 35 (889) 4 (102) 24.5 (622) Masts in upper position * Exit conveyors are optional L 90 (2290) max 20 (510) min 31 max ** Casters are optional Product Use: User is responsible for determining whether the product is fit for a particular purpose and suitable for user’s method of application. Box drive belt speed: 75 fpm Operating conditions: Use in dry, relatively clean environments at 40☏ to 120☏ with clean boxes. crated Operating rate: Up to 30 boxes per minute depending on box length. Contact your 3M sales representative for power requirements not listed above. Machine: Power: Electrical - 115 V, 60Hz, 3.8A, 440 watts, 8 ft. Width: 1.5 inches minimum to 2 inches maximum Roll diameter: up to 16 inches maximum on a 76.2mm diameter on 3 inch diameter core. Stainless Steel Adjustable Case Sealer 700a-s F Box Travel A Control Side H A B Tape: Scotch™ brand pressure sensitive box sealing tapes. 5 Box Height boxes should be test run to ensure proper machine performance. However, if Box length in Direction of Seal is less than. Footprint: Infeed/Exit Conveyor W F F A Note: The 3M-Matic™ 700a-s can accommodate most boxes within the size range listed above. Contact your 3M sales representative for information. Special modifications may be available for carton sizes not listed above. Size: Min Max Length 6" (150mm) 21.5" (546mm) Width 6" (150mm*) No limit Height 4.75" (121mm) 24.5" (622mm) *3.75" with taping heads adjusted to apply 2" tape leg lengths and upper mast stops relocated. inch single or double wall, B or C flute. Using only 110 volt AC and most industry standard tapes including filament tapes from 1/2 inch wide up to 2 inch wide, the Tach-It Model #6425 can seal up to 40 packages per minute increasing operator productivity over hand taping, is easily adjusted for tape length and width, requires no training or tools for tape changes, and has a small table top design which allows it to be used anywhere it is needed.3M-Matic™ Stainless Steel Adjustable Case Sealer 700a-s Specifications: Box: Style: Regular slotted container (RSC) Bursting test: 125 to 275 lbs. This actuates the machine and the desired length of tape is securely applied. The operator places the box to be sealed onto the platform of the machine and pushes the box forward against the upper pressure pad. Perfect for sealing all types of corrugated, chipboard boxes and cartons, the Tach-It Model #6425 is simple to use. The Tach-It Model #6425 L-Clip Box Sealer securely applies various lengths and widths of most types of packaging tapes, including filament tapes, up to 2 inch wide from the side to the bottom of a box. Tach-It 6425 Semi-Automatic L-Clip Tape Dispenser TACH-IT > Tape Dispensers and Applicators >
0 Comments
Leave a Reply. |